Evoque Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1 (Edited)
Hello everyone,

I had a solid Check engine light, I scanned it with bluedriver and it showed Misfire on cylinder 4 P0304 and suggested that I should change spark plugs/ignition coil. I changed the four spark plugs and and cleared the code. Check engine light came back on again after couple days (Same code)
I changed the ignition coil on Cylinder 4 only this time and went for a drive, I scanned the car after an hour and it showed Pending trouble code P0304 (Not active code). I am not too sure what's causing this misfire anymore. Did anyone had the same issue ? Please and thank you

It's a 2016 Evoque SE, Gas
 

·
Registered
Joined
·
59 Posts
Sorry, read your post but have as much idea as you do 🤔🙁 I would have suggested everything you have already done.
 
1 - 4 of 4 Posts
Top