[Krum]

Why did you need to replace the crankshaft pulley?
Are they common to fail on this vehicles?

 

[autoin]

Email sent.

Hi Rsquared, could you please send me the mail too? The same issue, everything replaced, engine seems to be ok, but P0016 is present ... Thanks!

 

[Rsquared]

Email sent.

 

[blakpolak]

@

Email sent.

Good day. Can you send me the instruction? I have the same problem with P0016 and P0017, no performance issues, timing chain replaced 40,000km ago. These two valves are generally loose. I don't know if they should be and this could be a problem? Mail: [email protected]

 

[Rsquared]

Email sent.

 

[lrescalante]

I know this is an older thread but I am having a similar problem. I had to replace the harmonic balancer/ drive shaft pulley and didn't know I had to mark the position. Now it won't start.

I have same issue where you able to resolve?

 

[Dr.1]

Super2ndgen, Welcome to the forum!

If you want to PM me your e-mail address, I will forward the e-mail I sent to GtKhali with sections of the Factory Service Manual, for installing the crankshaft pulley. If you need to reset the crankshaft pulley, you will need a Land Rover special tool, which is listed in the e-mail.

Can you forward the email to please ;same problem .... they changed the pulley without marking and now same error codes

 

[Rsquared]

I will be glad to send you the info I have, but I need your email address. You can PM it to me, if you want to keep it private.

 

[Evoque_pinball]

Rsquared - I also am having issues with the P0016 after the timing chain was replaced. Can you send me over the procedure. Engine runs great. Just this code will not go away.

email: [email protected] . com

 

[Rsquared]

Email sent.