Evoque Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Back in August I was driving the car when I had 3 errors come up on my dash
HDC stability control not available
ABS fault
PAS
after driving for a period of time my power assisted steering would then cut out.

I paid for diagnostics and mechanic said it was rear wheel speed sensor and replaced this and errors still come up.
after driving for a period of time my power assisted steering would then cut out.

I paid for diagnostics and mechanic said it was rear wheel speed sensor and replaced this and errors still come up.
It’s been to a Land Rover specialist that’s checked several things listed below and could not find the fault , wiring looms were mentioned , abs Module , steering angle module

“The Fault code I narrowed it down to was U0001-87 High speed can communication bus off this is found in the abs module then in turn puts a fault code in the steering angle sensor.

Checked ground and earth to steering angle sensor then replaced steering angle sensor
Checked wiring harness down the steering column to ODB port all ok
Replaced part number LR024631
Checked ground and earths on abs module
Replaced abs module
Ran new CAN high/ low wires from abs module to cjb
Carried out harness body push pull test to recreate the fault whist stationary this only happed once after some time.
replaced nearside front wheel bearing (mapping showed a spike on front NS wheel bearing when fault happed.”

It’s now been in Land Rover for 3 weeks and done the £200 diagnostics that I was told would pin point the problem and still no further forward they have taken files from the computer and sent them to specialists and , They changed the steering angle sensor module and they stated that it had cleared and then developed another fault HDC which was there originally anyway

Ive seen this fault appear on forums so it’s not like it’s a new unique problem with the car so if anyone out there can shed some light on this as I am at the end of my tether with it and losing the will to live . How can it be in the garage that makes the car and them not know what’s wrong!!
Thanks in a
 
1 - 1 of 1 Posts
Top