Evoque Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
2012 evoque non dampening control arms.

Went to change my lower control arms and when I was jacking up the knuckle to get the ball joint in the cv axel popped out. The boot is still on just stretched a little.

Currently I have the sway bar link disconnected and the lower control arm removed trying to get the control arm in and the cv axel in.

If I take the strut out I can get the axel back in if I beat on it with a 2x4 and a hammer but when I put the strut back in the axel pops out again.

Any tips to get the axel in and the lower control arm would be greatly appreciated.
Thank you!
 
1 - 1 of 1 Posts
Top