Evoque Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
Being such a new vehicle, I cannot source any online diagrams. Contacted LR to see if the parts/service dept could help decipher it but no dice. I'm hoping one of you good folks could shed some light on this:

I'm wanting to paint the side molding(the protrusion on the bottom 1/3 of the side panels), side scuttles and front/rear "skid plates"(the gray area). I therefore, need to figure out how these come off. The side scuttle/side moulding seem to just pop off but I'm kinda wary of breaking a tab underneath. As far as the skid plates go, do the bumpers need to come off? Painting the parts while still being on the vehicle isn't going to cut it.
 
1 - 3 of 3 Posts
Top